6. Component toolbar

after selecting an object, you can make the following operations through component toolbar：

1. Commonly used operation

  1. Multi-select: After opening it, several objects can be continuously selected, and click to close it. On the desktop computer, you can press the Ctrl button on the keyboard and select several objects, or press Shift and drag the mouse, to pull out the CheckBox to check several objects。
  2. Move to the upper layer: Move the component to the upper layer
  3. Move to the lower layer: Move the component to the lower layer
  4. Move to the topside: Move the component to the topside
  5. Move to the lowest layer: Move the component to the lowest layer
  6. Object lock: After selecting a component, you can press [Lock] to prohibit moving or modifying any components. Locked components cannot be selected.。
  7. Unlock: Press it to pop up the list of locked components, you can check components, or press the Unlock button near it to unlock it。
  8. Copy: Copy and clip the object, or paste the components in the ClipBook
  9. Cut: Cut the component/object and put it in the Clipbook
  10. Paste: Paste the copied objects/cut objects
  11. Replace: Replace the copied objects/cut  objects at same location
  12. Align tool: View [Align tool]
  13. Shield: Make the object into one shape which shall be selected by the user。 Please note that some objects cannot be shielded
  14. Group: Make several objects into one group for convenient shift
  15. Dissolve group：Dissolve the object groups or shield

2. Align tool


  1. Horizontal flip: Make the objects horizontal flip
  2. Vertical flip: Make the objects vertical flip
  3. Upshift: Upshift the objects by 10 pixels
  4. Downshift: Downshift the objects by 10 pixels
  5. Left shift: Left shift the objects by 10 pixels
  6. Right shift: Right shift the objects by 10 pixels
  7. Counter-clockwise rotation : Counter-clockwise rotation of 10 degrees
  8. Clockwise rotation : Clockwise rotation of 10 degrees
  9. Reset Size: Reset the object to the original size.
  10. Zoom to page: Zoom the object to make it meet the page size
  11. Align left: Make the objects align to the left。
  12. Center Vertically: Align all objects from left to right, on the vertical center point
  13. Align right：Make the objects align to the right
  14. Align top: Make the objects align to the top
  15. Center vertically：Align all objects from left to right, on the vertical center point
  16. Align bottom: Make the objects align to the bottom
  17. Horizontal split：Separate the objects from left to right with average spacing
  18. Vertical split：Separate the objects from top to bottom with average spacing
  19. Page opening：After opening it, the above align tools can be used by taking the page as the benchmark

Next Topic：Introduction to Components